Draw Resistor Symbol

This tool automatically draws a resistor symbol on a line, commonly used in electrical and fire protection sequence drawings.

Function

It simplifies the placement of resistor symbols by aligning them to an existing line.

Symbol Scaling

Similar to other sequence symbol tools (like FUSE), you can adjust the size of the symbol using the FAC command. The base size (Factor 1) corresponds to a circular diameter of approximately 3mm in other symbols.

Compatibility

This is a dedicated Cadopilar Lisp tool and works only within Cadopilar.

The resistor symbol is automatically drawn.

1. 1.Type JH in the command line and press Enter.
2. 2.Select the Line where the resistor will be placed.
3. 3.Click a point to define the Direction (along the line).

To change the size

If the symbol is too small or large, type fac and press Enter, then input a new scale factor (e.g., 2 for double size).